Thinkware - Q200 (Front)

Whatever you pick, I’d recommend against a camera that dangles off a mount unless it’s very small. I tried a Thinkware Q200 but I had to take it off immediately bc the Tacoma windshield is so small, it distracted my view no matter where I tried mounting it. I got a Viofo A229 instead and like another commenter, I mounted it in the black dot area of the windshield next to the mirror and I hardly notice it.

There a several good options. I use the Thinkware Q200. Performance is good and you can power it from the Homelink Rearview Mirror with an adapter from MX5Things.

I have the Thinkware q200 front and back. It works fine. $170

Thinkware Q200 front and rear. Get OBD-II power pass through adapter. Tuck the wires in the headliner and down the A pillar. EZ PZ.

I have a thinkware Q200 and I like it well enough. No real issues or complaints.

I got thinkware Q200 recommended by the dashcam subreddit. It’s a two way with parking mode. Best Buy installed it with a hard wire for $99.

Thinkware q200 front & rear, it has impact detection when switched off.

ThinkWare q200. The exact one Ford sells on their accessories site is sold by the manufacturer and Bestbuy for like $150-170.

ThinkWare Q200, Ford sells it via the accessories portal, but it's significantly cheaper from BestBuy. Simple set up, 2K UHD front sensor 1080p rear sensor. Front camera is the size of a large candy bar, rear sensor is about 1/2 the size of a AA battery. You can get a harness to hardware it to the fuse panel under the steering wheel.

Thinkware Q200 bit expensive but worth it

Going to throw my 2 cents in. I got a Thinkware Q200 (front and rear). I could not find a good spot to hotwire it in the 2025. The fuse adapters I bought were too clunky. I ended up getting ForScan and an OBDLink. With this, I can make it so the cigarette outlet turns off power at 30 seconds instead of 30 minutes (I didn’t want the dashcam on all the time)